Rád bych se zeptal, jaké mám vyvozovat závěry?
výpis smartctl -a /dev/sdb
- Kód: Vybrat vše
smartctl 5.43 2012-06-30 r3573 [x86_64-linux-3.8.0-33-generic] (local build)
Copyright (C) 2002-12 by Bruce Allen, http://smartmontools.sourceforge.net
=== START OF INFORMATION SECTION ===
Device Model: Hitachi HTS547575A9E384
Serial Number: J2590020CMTKTG
LU WWN Device Id: 5 000cca 728c8ff4c
Firmware Version: JE4OA50A
User Capacity: 750 156 374 016 bytes [750 GB]
Sector Sizes: 512 bytes logical, 4096 bytes physical
Device is: Not in smartctl database [for details use: -P showall]
ATA Version is: 8
ATA Standard is: ATA-8-ACS revision 6
Local Time is: Sun Nov 24 10:59:18 2013 CET
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: PASSED
General SMART Values:
Offline data collection status: (0x00) Offline data collection activity
was never started.
Auto Offline Data Collection: Disabled.
Self-test execution status: ( 0) The previous self-test routine completed
without error or no self-test has ever
been run.
Total time to complete Offline
data collection: ( 45) seconds.
Offline data collection
capabilities: (0x5b) SMART execute Offline immediate.
Auto Offline data collection on/off support.
Suspend Offline collection upon new
command.
Offline surface scan supported.
Self-test supported.
No Conveyance Self-test supported.
Selective Self-test supported.
SMART capabilities: (0x0003) Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01) Error logging supported.
General Purpose Logging supported.
Short self-test routine
recommended polling time: ( 2) minutes.
Extended self-test routine
recommended polling time: ( 203) minutes.
SCT capabilities: (0x003d) SCT Status supported.
SCT Error Recovery Control supported.
SCT Feature Control supported.
SCT Data Table supported.
SMART Attributes Data Structure revision number: 16
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE
1 Raw_Read_Error_Rate 0x002f 100 098 062 Pre-fail Always - 0
2 Throughput_Performance 0x0025 100 100 040 Pre-fail Offline - 0
3 Spin_Up_Time 0x0023 177 100 033 Pre-fail Always - 1
4 Start_Stop_Count 0x0032 100 100 000 Old_age Always - 971
5 Reallocated_Sector_Ct 0x0033 100 100 005 Pre-fail Always - 0
7 Seek_Error_Rate 0x002f 100 100 067 Pre-fail Always - 0
8 Seek_Time_Performance 0x0025 100 100 040 Pre-fail Offline - 0
9 Power_On_Hours 0x0032 097 097 000 Old_age Always - 1542
10 Spin_Retry_Count 0x0033 100 100 060 Pre-fail Always - 0
12 Power_Cycle_Count 0x0032 100 100 000 Old_age Always - 653
183 Runtime_Bad_Block 0x0032 100 100 000 Old_age Always - 0
184 End-to-End_Error 0x0033 100 100 097 Pre-fail Always - 0
187 Reported_Uncorrect 0x0032 100 100 000 Old_age Always - 17180196864
188 Command_Timeout 0x0032 100 099 000 Old_age Always - 137443803144
190 Airflow_Temperature_Cel 0x0022 072 058 045 Old_age Always - 28 (Min/Max 22/30)
191 G-Sense_Error_Rate 0x0032 100 100 000 Old_age Always - 71
192 Power-Off_Retract_Count 0x0032 100 100 000 Old_age Always - 4653127
193 Load_Cycle_Count 0x0032 100 100 000 Old_age Always - 4685
196 Reallocated_Event_Count 0x0032 100 100 000 Old_age Always - 0
197 Current_Pending_Sector 0x0032 100 100 000 Old_age Always - 0
198 Offline_Uncorrectable 0x0030 100 100 000 Old_age Offline - 0
199 UDMA_CRC_Error_Count 0x0036 099 099 000 Old_age Always - 482
223 Load_Retry_Count 0x002a 100 100 000 Old_age Always - 0
SMART Error Log Version: 1
ATA Error Count: 500 (device log contains only the most recent five errors)
CR = Command Register [HEX]
FR = Features Register [HEX]
SC = Sector Count Register [HEX]
SN = Sector Number Register [HEX]
CL = Cylinder Low Register [HEX]
CH = Cylinder High Register [HEX]
DH = Device/Head Register [HEX]
DC = Device Command Register [HEX]
ER = Error register [HEX]
ST = Status register [HEX]
Powered_Up_Time is measured from power on, and printed as
DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes,
SS=sec, and sss=millisec. It "wraps" after 49.710 days.
Error 500 occurred at disk power-on lifetime: 1525 hours (63 days + 13 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 7f 0b 56 0c Error: WP at LBA = 0x0c560b7f = 206965631
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
61 00 80 bf 65 22 40 00 00:19:07.078 WRITE FPDMA QUEUED
61 00 78 bf 61 22 40 00 00:19:07.070 WRITE FPDMA QUEUED
61 00 70 bf 5d 22 40 00 00:19:07.061 WRITE FPDMA QUEUED
61 00 68 bf 59 22 40 00 00:19:07.051 WRITE FPDMA QUEUED
61 00 60 bf 55 22 40 00 00:19:07.043 WRITE FPDMA QUEUED
Error 499 occurred at disk power-on lifetime: 1525 hours (63 days + 13 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 4f 01 db 0d Error: WP at LBA = 0x0ddb014f = 232456527
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
61 00 80 a7 fa 89 40 00 00:17:29.121 WRITE FPDMA QUEUED
61 00 08 a7 f6 89 40 00 00:17:29.111 WRITE FPDMA QUEUED
61 00 00 a7 f2 89 40 00 00:17:29.102 WRITE FPDMA QUEUED
61 00 78 a7 ee 89 40 00 00:17:29.094 WRITE FPDMA QUEUED
61 00 70 a7 ea 89 40 00 00:17:29.084 WRITE FPDMA QUEUED
Error 498 occurred at disk power-on lifetime: 1525 hours (63 days + 13 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 ff 75 cd 0f Error: WP at LBA = 0x0fcd75ff = 265123327
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
61 00 a0 07 22 72 40 00 00:16:56.065 WRITE FPDMA QUEUED
61 00 98 07 1e 72 40 00 00:16:56.055 WRITE FPDMA QUEUED
61 00 90 07 1a 72 40 00 00:16:56.046 WRITE FPDMA QUEUED
61 00 88 07 16 72 40 00 00:16:56.039 WRITE FPDMA QUEUED
61 00 80 07 12 72 40 00 00:16:56.030 WRITE FPDMA QUEUED
Error 497 occurred at disk power-on lifetime: 1525 hours (63 days + 13 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 ff 72 b8 0f Error: WP at LBA = 0x0fb872ff = 263746303
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
61 00 08 17 4f 5d 40 00 00:16:28.296 WRITE FPDMA QUEUED
61 00 00 17 4b 5d 40 00 00:16:28.288 WRITE FPDMA QUEUED
61 00 f0 17 47 5d 40 00 00:16:28.279 WRITE FPDMA QUEUED
61 00 e8 17 43 5d 40 00 00:16:28.270 WRITE FPDMA QUEUED
61 00 e0 17 3f 5d 40 00 00:16:28.263 WRITE FPDMA QUEUED
Error 496 occurred at disk power-on lifetime: 1525 hours (63 days + 13 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 ff 73 a2 0f Error: WP at LBA = 0x0fa273ff = 262304767
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
61 00 a0 2f b9 46 40 00 00:15:59.332 WRITE FPDMA QUEUED
61 00 98 2f b5 46 40 00 00:15:59.322 WRITE FPDMA QUEUED
61 00 90 2f b1 46 40 00 00:15:59.313 WRITE FPDMA QUEUED
61 00 88 2f ad 46 40 00 00:15:59.305 WRITE FPDMA QUEUED
61 00 00 2f a9 46 40 00 00:15:59.295 WRITE FPDMA QUEUED
SMART Self-test log structure revision number 1
Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error
# 1 Short offline Completed without error 00% 1542 -
# 2 Extended offline Completed without error 00% 99 -
# 3 Short offline Completed without error 00% 94 -
SMART Selective self-test log data structure revision number 1
SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS
1 0 0 Not_testing
2 0 0 Not_testing
3 0 0 Not_testing
4 0 0 Not_testing
5 0 0 Not_testing
Selective self-test flags (0x0):
After scanning selected spans, do NOT read-scan remainder of disk.
If Selective self-test is pending on power-up, resume after 0 minute delay.